Install Ubuntu Core
We will walk you through the steps of flashing Ubuntu Core on an Intel Joule. At the end of this process, you will have a board ready for production or testing snaps.
- An Ubuntu SSO account with an SSH key
- An Intel® Joule board with BIOS updated to version #193 (update instructions)
- 2 USB 2.0 or 3.0 flash drives (2GB minimum)
- A monitor with an HDMI interface
- A Mini HDMI to HDMI cable
- A USB keyboard and a mouse
- A USB Hub with space for 4 devices
- An 802.11 a/b/g/n WiFi network with Internet access
- An Ubuntu 18.04.3 LTS image
- An Ubuntu Core image
Setup an Ubuntu SSO account
Download Ubuntu Core
Flash the USB drives
Install Ubuntu Core
- Connect your USB hub, keyboard, mouse, monitor to the Joule.
- Insert the first USB flash drive, containing Ubuntu 18.04.3 LTS.
- Power-up the Joule board, boot-up the device from USB and select “Try Ubuntu without installing” in the first boot menu.
- Once the system is ready, insert the second USB flash drive.
Open a terminal and run the following command, where <disk label> is the name of the second USB flash drive:
xzcat /media/ubuntu/<disk label>/ubuntu-core-16-joule.img.xz | sudo dd of=/dev/mmcblk0 bs=32M status=progress; sync
- Remove all USB flash drives and reboot the system, it will reboot from the internal memory now containing Ubuntu Core.
First boot setup
- The system will boot then become ready to configure.
- The device will display the prompt “Press enter to configure”.
- Press enter then select “Start” to begin configuring your network and an administrator account. Follow the instructions on the screen, you will be asked to configure your network and enter your Ubuntu SSO credentials.
At the end of the process, you will see your credentials to access your Ubuntu Core machine:
This device is registered to <Ubuntu SSO email address>. Remote access was enabled via authentication with the SSO user <Ubuntu SSO user name> Public SSH keys were added to the device for remote access.
Once setup is done, you can login with SSH into Ubuntu Core, from a machine on the same network, using the following command:
ssh <Ubuntu SSO user name>@<device IP address>
Your user name is your Ubuntu SSO user name, it has been reminded to you at the end of the account configuration step.